How appropriate feed mixer [mixer] now in our society is a very common device, now it is mainly used in the development of our industry, we should be how to give our mixer feeding it? Following on from our Rubber Machinery Co., Ltd., Dongguan City, the same boat as us to explain it! Our first mixer at feeding time do not put chunks of hard plastic material added in the middle of the roller section, where more synthetic moment, up to 2820 tons cm. Feeding quantity to gradually increase the weight shall not exceed the feed block device manual on feeding sequence steeled have added. This is a relatively easy, and chunks of rubber roll away suddenly inserted will cause overload out, not only easy to make safe gasket is damaged, and, once the security gasket failure, it will endanger the roller. So we are going to pay special attention to the problems of these details, do not be careless. Main products: plastic cutting machine, turning plastic machine, hoist, mixer, mixing machine (open mill), opening film machine line, and accessories